| PM | Quote | Reply | Full Topic |
Hails from the land of rust!
Joined: Sat Oct 21st, 2017
Posts: 1368
Status:
Offline
Reputation: 
Reputation Points: $user_rep
Looks like you're lucky enough to have the parts still generally available for your year! I'll link the rivnuts i used below, also the tool i used.
Drilling actually wasn't something i was or would be worried about, but it didn't look like it was needed, the only reason i saw to drill was if i bought the 'wrong' sized rivnuts.
The holes were 7mm in mine, i don't see why they would change 5 years later, so it should be good for you too, there will be 4 holes each side, i only showed 3 done in the pic.
There is a bracket component (bolts to the holes with the rivnuts in them)
There is a part called the handle trim (screws to the bracket)
There is a pillar trim piece (with the holes for the assist handle)
Rivnuts (7mm M5)
Rivnut Tool, M5 size, screw type.
Here's the 4 holes done.
Attachment: IMG_20180215_175142.jpg (Downloaded 45 times)
____________________
2002 - 3.0 - 4x2 - Edge
Upgrades/Maintenance log