| PM | Quote | Reply | Full Topic |
Hails from the land of rust!
Joined: Sat Oct 21st, 2017
Posts: 1368
Status:
Offline
Reputation: 
Reputation Points: $user_rep
So far as i've been able to discern, there are two ways of dealing with the stud length.
1) Your wheels (especially alloys) can/will have cut outs in the stud areas, they can be deep enough to accommodate the studs. You have to check them.
2) Get shorter studs, not sure how easy that is, but changing them doesn't seem *too* hard.
3) Grind off your existing studs, i believe flush with where your wheel and nut combo sits when it's all attached.
I *think* the stock studs are 1.25 as you say, and i personally wouldn't want spacers any more than 1 inch, maybe even just 25mm spacers - with the stock wheels at least.
____________________
2002 - 3.0 - 4x2 - Edge
Upgrades/Maintenance log