| PM | Quote | Reply | Full Topic |
Coal miner
Joined: Sat Nov 25th, 2017
Posts: 1738
Status:
Offline
Reputation: 
Reputation Points: $user_rep
Depends. Is the rear end you bought out of a ranger? If so and you are keeping the same size tires I wouldn't flip it. If you are going bigger in the back for tires, flip it. If you are putting an expo rear end in definitely don't flip it will be low enough with the rear end on top of the springs. Might even want to raise it a little. If an expo rear end and you are busting the perches and welding them on the other side.. flip it?
You need to toss a 6 sided coin to figure it out. Whatever you do don't have the front higher than the back as you will be labeled LOL.
I have a torsen rear axle that I'm putting in. I'm leaving the spring perches where they are. I'm just debating on flipping the rear spring hangers upside down to lower the back of the truck. I have an old set of dream beams for the front. Just not sure if I want to lower the truck or not
____________________
1995 ranger splash (pieces)