| PM | Quote | Reply | Full Topic |
Old Bastard !
Joined: Fri Dec 22nd, 2017
Location: California USA
Posts: 2108
Status:
Offline
Reputation: 
Reputation Points: $user_rep
The bed has a crack on the left, hard to see from the pic I didn't take of it.
I've never worked with fiberglass is it easy or a pain in the butt?
Working with Fiberglass is messy but not hard, time consuming, and very dusty from the sanding... wear a good mask ! That shouldn't be a problem !
I found easiest... work with as flat a piece as possible; so take the bed side off, just a few torx bolts.
Make sure you start with a flat area, and get some of the resin the crack itself !
Reinforce on the inside.
Just my way !
Last edited on Sun Jun 21st, 2020 11:13 pm by Scrambler82
____________________
Ltr,
2003 EDGE, Std Cab, Steppie, E4 Red, 5sp, 4x
5" SuperLift, 33" x 12.50 x 15"
Hurst Shifter
Mod'd Backrack to fit Steppie
Front and Rear Bumpers by Custom 4x4 Fabrication, OK; now Mike's Welding and Fabrication.
Working on more Mods, just need more time, longer days would work !