| PM | Quote | Reply | Full Topic |
Mustang Nut
Joined: Sun Oct 22nd, 2017
Location: Horsepasture, USA
Posts: 1692
Status:
Offline
Reputation: 
Reputation Points: $user_rep
1st pic, I drilled a 7/8" hole in the l/s rear inner fender panel & ran the harness through a grommet out under the fender.
2nd pic, Harness re-enters the engine compartment through a grommet in the lower part of the l/s front inner fender panel & through a hole in the lower l/s of the radiator support out to the front of the car.
3rd pic, All the f/e lighting wires & horn wire temp in place until I can hang the fenders so I can cut the wires to length & install the plug ends.
____________________
21 Bronco Sport Big Bend (Wife's DD)
05 F150 XLT Reg Cab, 2WD, 5.4L, Auto (My DD)
69 Mustang Coupe 5.0, 5 spd 9" rear(Project)
14 Kawasaki Vulcan (Wife's Toy)