View single post by Michael71009

Posted: Sun Dec 31st, 2017 03:45 pm

Quote

Full Topic

Michael71009
Mikey Mike

Joined: Sat Dec 16th, 2017

Location: Maysville, Kentucky USA

Posts: 46

Status:

Offline

Reputation:

Reputation Points: $user_rep

Member's Gallery

I managed to take a look at, while I was under there the new shocks went on. Rear passenger was bad, it wouldn't rebound at all. But, couldn' get lucky enough for that to fix my problem. I layed a level across the bed rails and the bubble is as far left as It can go. So I measured both sides from the ground to the center of the wheel well. Driver side is 33 3/8 passenger side is 34 3/4. The front fenders measure out equal to the ground. I have not measured the back of the cab corners to the ground yet. I will try to do that either this evening or tomorrow sometime. But from looking at the cab bushings they look fairly decent along with the metal on the cab. The cross channels under the bed are also in good shape.
I did notice that on the drivers side the lines in the body don't quiet match up, the bed lines are a tad bit higher, on the passenger side their dead on. So im back at square 1. I could shim the passenger side up which would make my body lines uneven loke the driverside. Only downfall to that is I'll know about it, and it will just continue to eat at me. Could I possibly have a weak leafspring? They both look good from what I can tell, along with the shackles and hangers.

____________________
2006 ford ranger sport 2wd standard shift 3.0 v6
2007 Nissan Altima 2.5s
2014 GMC sierra dc sb 4wd