| PM | Quote | Reply | Full Topic |
Mustang Nut
Joined: Sun Oct 22nd, 2017
Location: Horsepasture, USA
Posts: 1692
Status:
Offline
Reputation: 
Reputation Points: $user_rep
If they're still available that's a plus...
I have to admit, at first I wasn't too wild about this at first but the more I get over the pillar plastic not being so called perfect, the more useful I see it as for the handles.
Was the passenger side done the same or did I see you just leave the overhead handle in place? or both on passenger side?
I did both l/s & r/s a pillar grab handles & left the on on the inside roof on the passengers side. BTW the grab handles over the passengers side door on the roof are the same ones for the a pillar, I just grabbed a couple from 2 different Rangers in the JY with the same interior color along with the screws & the screw covers. I also have 2 extra grab handles.
Jim, I will pull one of the moldings off & pull one of the screws out of the riv nut & check it against the extra ones I have & give you the size on them. The tool seemed from what I remember pulled ok, also the riv nuts I used on mine were brass colored ones. I spent the $26.97 & got the one pictured in the link to Summit Racing because I had the need to do some on my 69 Mustang.
____________________
21 Bronco Sport Big Bend (Wife's DD)
05 F150 XLT Reg Cab, 2WD, 5.4L, Auto (My DD)
69 Mustang Coupe 5.0, 5 spd 9" rear(Project)
14 Kawasaki Vulcan (Wife's Toy)