"Added by eddie, posted by 410custom"

The turn signal + wires were fed to the multifunction switch where I tapped into the left and right turn signal wires
[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif][font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]
The heater wires were run to the drivers side of the dash just next to the radio bezel, perfect spot to mount heater relay/ controller

Lets test the turn signals



I almost forgot the CAMERA System has a shock sensor
This way if you are away from vehicle and it gets bumped the system records whatever is happening
Shock sensor has a sensitivity adjuster wheel





Mounted here for easy access



Now I wanted to put the interior back together so I could find the good spot for heated mirror switch




One more thing to wire up first
the heated seat switches and relays
Power wires from fuse box and to seats already run to the center console (red)




I ordered some nice billet pushbuttons and some pre wired and fused relays



everything for the seat heaters wired, will be mounted in the console here













switch location and mounting










now put it all together final mock up (before paint)
and I can select spot for heated mirror switch, I wanted it to make sense

interior going together all wiring finalized and tucked in
Can see the turn signal connections at the multifunction switch plug and also the heated mirror controller zip tied to metal support on the right
Plenty of airflow around that relay
All wires from everything I have run protected from sharp edges, bundled and tied in place

Also the blue masking tape, I Identified each power wire and system so future mechanics, the trucks owner, etc can more easily troubleshoot













Found my spot for the [font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif][font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]heated mirror system controller, you hit the toggle button it comes on for 10 minutes then shuts off until you reset the toggle
Neat!




Not an easy fit to put switch here but I was determined



Had to be placed perfectly so the back of switch goes into the square access hole in the metal
The mirror mounting stud had to be shortened to allow room for back of switch and wires




wont push back far enough yet

[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]

Last edited on Sun May 28th, 2023 10:17 pm by Eddie Money