"Added by eddie, posted by 410custom"

So now with the console, shifter, pcm, and seats sorted out it's was time to install mountain of electronics into this dash/ interior
[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif][font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]


Pumpkin double din head unit with navigation
360 degree Birds Eye camera system
Heated seats switches and wiring
Arb compressor and locker switches
Usb ports for dash access for camera system and stereo memory storage
Turn signal and heated side mirrors
Finishing the instrument cluster and more

So before I go to
Much further I needed to run some power into the interior for the seats and console. If you remember from earlier in the build we had some power feed wires left inside the under hood fuse box. I used 3 of the factory fuse spots here and their respective wires. 1
40 amp fuse for seat power, 1 40
Amp fuse for seat heaters and 1 30
Amp fuse for accessory battery constant power. Wires were run through the firewall pass through grommet and into the console/ dash. Fuses were put back in these three spots

[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]

[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]

[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]

Last edited on Sun May 28th, 2023 05:28 pm by Eddie Money