[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]

[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]

[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]

[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]

[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif][font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif][font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]going to need to source a non column shift shroud, or mount something cool here later?



As discussed before PATS not needed




halo/wiring removed from column

Truck is prepared the holley PCM battery harness was run through the firewall and into engine bay then the steering went into the dash



Holley wires going through factory wiring grommet






routed, PCM has power

Floor wiring: seats, t case/bed wiring in place



Look ma clean floors

Floor laid back down
Steering in........ first look at the Holley PCM completely connected (one red wire to ignition switch, that's next)
There is talk of using a different steering wheel or re wrapping this one.... after truck is running/driving








[url=https://www.explorerforum.com/forums/threads/410customs-builds-a-2007-ranger-v8-custom-truck-build-project-ranger-premier.481492/reply?quote=3963933][/url]

[font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif][font="Segoe UI", "Helvetica Neue", Helvetica, Roboto, Oxygen, Ubuntu, Cantarell, "Fira Sans", "Droid Sans", sans-serif]it is loose, not mounted, I have not chosen the final location yet... the new console is quite roomy underneath
However the shifter will take up a bunch of space. I would like to make the led's visible, we shall see

This is how I splice into the run/start power feed at the ignition switch












and the holley PCM wiring at the battery




You bend the little tabs back and the terminal tighten bolts will come out, then I clean between the clamp with emery board and install the new ring terminal








Ignition wires installed



I am using these Motorcraft wires until the Taylor wires I ordered for this truck get here (backorder till October!)
These wires are leftover from another project

Last edited on Mon Sep 26th, 2022 03:45 pm by Eddie Money