| PM | Quote | Reply | Full Topic |
Joined: Tue Sep 17th, 2019
Location:
Posts: 36
Status:
Offline
Reputation: 
Reputation Points: $user_rep
| View single post by ylecoyote | |||||||||
| Posted: Tue Aug 4th, 2020 07:41 pm |
|
||||||||
|
ylecoyote Joined: Tue Sep 17th, 2019
Location:
Posts: 36
Status:
Offline
Reputation: Reputation Points: $user_rep
|
Well I wasn't able to try it until tonight I had my wife in the hospital again but it's all good she's out now. And yess cancer SUCKS!!!!! Like I said I tried it tonight and no dice. I think one issue is the signal return or number one terminal says in the switch diagram goes to the number one spot and also the diagram for the controller says that it is the signal return instead sooooooooooooo.the other issue I think maybe the vss from the transfer case it has one green wire and one blue wire but I'm not using them so I'm not sure if that vss input is just looking for mili volts when moving and if so do I need to ground one of the vss wires on the tcase in order to produce voltage and then what wire is ground. The last issue is pathetic nss on my safety switch I believe it's just completing a ground circuit to the starter relay in my televork controller and I'm not sure what the Motorola controller is looking for as an input ground or power? Well I know this was a lot I'm doing research now to see if I can find out anything out but I'm hoping you may already have this info. Again thanks again for all your help
|
||||||||
|
| |||||||||