| PM | Quote | Reply | Full Topic |
Idahome
Joined: Wed May 2nd, 2018
Posts: 2165
Status:
Offline
Reputation: 
Reputation Points: $user_rep
Cut the wires, loop the vacuum lines together = should be fine!
As long as you remove the vacuum feed from the engine to the vacuum hubs when you remove the hubs, that is all that is required. Cutting wires or removing the whole system like I try to do is just bonus.
I remove all lines from under the truck, the ones that go from the solenoid to each knuckle
Then I remove the solenoid
Then I loop the trucks vacuum lines back to itself by removing the tee
____________________
I build custom RBV, specializing in drivetrain conversions, wiring, suspension and complete custom trucks