| PM | Quote | Reply | Full Topic |
Idahome
Joined: Wed May 2nd, 2018
Posts: 2165
Status:
Offline
Reputation: 
Reputation Points: $user_rep
Oh man I laughed so hard at that. I guess I'm taking the homeschool thing a little too seriously eh?
I do not need any pictures from the book, you need to lookup the wires on the Ranger side of things and see if the pins in question match up.
Without the right book I cannot confirm any of these wires.
So I sat down and finished re-connecting the two different harness back together. What I'm left with on the explorer side is pin 17,18, 24,28,33,34,36,37,39,
Granted 34 is just a ground to which I'll run to the body. For the rest well... I'm not too sure what to do.
Pin 17 circuit 791 pressure transducer output-fuel tank
Pin 18 circuit 351 signal return fuel tank
Pin 24 circuit 329 start signal feed
Pin 28 circuit 394 pcm accel signal
Pin 33 circuit 463 electronic shift control module feed
Pin 36 circuit 34 positive feed to heated O2 sensors
Pin37 circuit a/c high pressure switch cutoff switch input
Pin 39 circuit 191 vapor Management valve
I have to double check the ranger pin out on the truck tomorrow so I can triple check that I'm wiring stuff correctly to the explorer harness
____________________
I build custom RBV, specializing in drivetrain conversions, wiring, suspension and complete custom trucks