| PM | Quote | Reply | Full Topic |
Old Bastard !
Joined: Fri Dec 22nd, 2017
Location: California USA
Posts: 2108
Status:
Offline
Reputation: 
Reputation Points: $user_rep
The Grease, "The secret is a copious amount of a high quality dielectric grease in the connector during install. Make sure the gasket surface is really clean when you put the 2 screws in. Then literally fill the front and back of the connector with dielectric grease, where the wires go in the back as well as where the spades go in the front. Put enough inside the cavity of the resistor so it squishes out when you push it in. Wipe"
What brand go grease do you use ?
I have Permatex Dielectric Grease and using CRS Cleaner !
Everything I have read say NOT to over use this stuff, reasoning please !
Thx
Last edited on Wed Feb 5th, 2020 12:07 am by Scrambler82
____________________
Ltr,
2003 EDGE, Std Cab, Steppie, E4 Red, 5sp, 4x
5" SuperLift, 33" x 12.50 x 15"
Hurst Shifter
Mod'd Backrack to fit Steppie
Front and Rear Bumpers by Custom 4x4 Fabrication, OK; now Mike's Welding and Fabrication.
Working on more Mods, just need more time, longer days would work !