| View single post by Mike69 | |||||||||
| Posted: Sun Dec 22nd, 2019 12:36 pm |
|
||||||||
|
Mike69 Mustang Nut  Joined: Sun Oct 22nd, 2017
Location: Horsepasture, USA
Posts: 1692
Status:
Offline
Reputation:  Reputation Points: $user_rep
|
Michael, my wife & I can remove the bed off my 00 Ranger using some marine grade rope tied to the inside bed hooks in an "X" pattern & my engine hoist. My wife operates the engine hoist while I guide the bed up, once it clears the rear bumper I hold the bed steady & she jumps in the truck & pulls it forward & then we set the bed on a pair of saw horses. When we stood the bed on the front panel so I could coat the bottom of the replacement bed I just ran a chain across the 2 rear in bed tie down hooks & lifted it with the engine hoist until it was clear of the saw horses then with my wife operating the hoist again I steadied the bed while she let the hoist down setting it on the front panel.  
____________________ 21 Bronco Sport Big Bend (Wife's DD) 05 F150 XLT Reg Cab, 2WD, 5.4L, Auto (My DD) 69 Mustang Coupe 5.0, 5 spd 9" rear(Project) 14 Kawasaki Vulcan (Wife's Toy) |
||||||||
|
| |||||||||