| PM | Quote | Reply | Full Topic |
Joined: Tue Sep 17th, 2019
Location:
Posts: 36
Status:
Offline
Reputation: 
Reputation Points: $user_rep
| View single post by ylecoyote | |||||||||
| Posted: Sat Sep 21st, 2019 08:26 pm |
|
||||||||
|
ylecoyote Joined: Tue Sep 17th, 2019
Location:
Posts: 36
Status:
Offline
Reputation: Reputation Points: $user_rep
|
I have the pin out but I'm not sure about several of the connections the first connector #4 iso bus #12 boo is it power input to allow for low rang? #16 neutral safety from the range selector also I assume for low range will it be power or ground? The second connector #1 signal return from? #12 vss can I use the vss from the transfer case because I'm using a gps drive for the VHX cluster and if so does the vss on the transfer case need a power supply or is the output in like mili volts or something else. Those are the wires I don't have connected and am assuming one or more is the reason for it not responding. Anyway thanks again for your help.
|
||||||||
|
| |||||||||