| View single post by wh23g3g | |||||||||
| Posted: Tue Jun 4th, 2019 08:24 pm |
|
||||||||
|
wh23g3g Joined: Sun Mar 11th, 2018
Posts: 130
Status:
Offline
Reputation:   Reputation Points: $user_rep
|
I reinstalled the original GEM module and tried to rewrite it using Forscan and it stopped halfway through and said service interrupted. That was the AS Built option. I tried it the other way where user defines specs. I chose the 225/70/14 tire size as it came with originally and tried to rewrite it and it again went halfway through the rewrite procedure and it said service interrupted. I still have two codes. I don't remember the code number. But I know one was for the accessory delay relay and the other was a seat belt switch code. I did a component test on the gem and when it was testing everything it did turn on the seat belt light, so the lamp isn't out, the chime did not come on. On the used GEM I got it would only flash the seatbelt light upon startup for about 4 seconds and that's it. So I swapped my old GEM back and it doesn't even turn on the seat belt light at all. I'm going to get another seat belt buckle this weekend from the salvage yard just to try since they are only $4.
____________________ 1998 Ford Ranger XLT 2.5 4R44E Automatic 4.10 non-limited slip, 1993 Ford Ranger XLT 2.3 M5 Manual, 3.45 non-limited slip |
||||||||
|
| |||||||||