View single post by Scrambler82
 Posted: Wed Mar 20th, 2019 03:32 pm
PM Quote Reply Full Topic
Scrambler82
Procrastinator Extraordinary


Joined: Fri Dec 22nd, 2017
Location: California USA
Posts: 1108
Status: 
Offline
Reputation: 
Reputation Points: 1508
Here is picture of the LED lighting I've mounted so far, I thought I had a picture with all of the LEDs turned on and the Gauge Faces in place but I can't find it.

You can see in the picture there are 4-Cree LED Bulbs in six OEM Positions, and a Strip of RED Cree LEDs around the outside edge.
If I remember correctly, the picture I don't have did show a very even lighting of the new Gauge Faces.
All of the smaller indicator bulbs (11) will be replaced with Buggman LED Bulbs... waiting to hear !



On the lower right side, there are five indicator light bulb positions, two are used, the other three will take the OEM Twist Sockets.
Thinking three Accessory Indicators could be installed.  (Sent The Buggman a PM, asking what he has to get these three indicators inplace so I don't have to disassemble the Cluster after assembly).

Another step forward, looking at the rear panel of this cluster housing, it appears these must have been used in earlier Rangers, i.e. Mechanical Speed-O Hole.

Ltr

Last edited on Wed Mar 20th, 2019 09:48 pm by Scrambler82



____________________
Ltr,
2003 EDGE, Std Cab, Steppie, E4 Red, 5sp, 4x
Large Tube Rear Axle, 31 Spline - FX4, 4.56 Gears, OX Locked
5" SuperLift, 33" x 12.50 x 15" BFG ATs,
Hurst Shifter w/Longer Replacement Shift Handle with (Homemade) Mounting Adapter; 1.5" up x 1" back.
Backrack mod'd to fit Steppie, Front and Rear Bumpers by Custom 4x4 Fabrication, OK.
Working on more Mods, just need more time, longer days would work !