| PM | Quote | Reply | Full Topic |
Idahome
Joined: Wed May 2nd, 2018
Posts: 2165
Status:
Offline
Reputation: 
Reputation Points: $user_rep
The converter takes a 3 bulb system and converts it to 2 or vise versa
Here are the installation instructions
https://assets.curtmfg.com/masterlibrary/56196/installsheet/CME_56196_INS.PDF
The converter takes the 3 bulb system which normally uses turn signal and brake together into a separate turn signal and brake wire so you can run the later model tails
It is normally used to convert a 2 bulb vehicle to run a normal 4 pin trailer plug, but since it works in both directions, for us it will convert the older 3 bulb tails into a 2 bulb tail without the need for relays and trigger wires, etc. Plus they are already weatherproof and designed to be wired in at the tail lights and remain weather tight
For $30 its a no brainer!!
This is what I used when I put 05 tail lights on the 99 V8 Stepside
Last edited on Tue Dec 18th, 2018 09:18 am by 410customs
____________________
I build custom RBV, specializing in drivetrain conversions, wiring, suspension and complete custom trucks