| PM | Quote | Reply | Full Topic |
Joined: Thu Nov 1st, 2018
Posts: 48
Status:
Offline
Reputation: 
Reputation Points: $user_rep
Ok, just an observation. If you have the 60/40 in you truck currently, dont you only need a driver side bucket seat? Cant the passenger side seat from the edge 60/40 be used to replace the driver side seat. I've never tried this but it sounds like itd work. Then you just recover or put matching seat covers with your desired material.
Probably, I just haven't found any decent buckets in colors I like. I did find a set but they were tan, and I don't want to deal with swapping covers. I like the color of the seats I got so I'll just stick with them. Once they're clean and modified (pretty simple) and once I get the rails swapped they'll look good I think.
Not sure if this is a no no here, but this is the procedure I was referring to with the seat mod from another forum.
https://www.ranger-forums.com/interior-exterior-electrical-123/how-60-40-bench-seat-40-40-bucket-seat-8285/
____________________
2016 VW 2dr GTI S 6spd manual OEM+ Euro Mods
2001 XLT standard cab 2.3L 5spd 2wd stepside
I'd rather drive hard than park hard
GO STARS!!!