View single post by JAMMAN

Posted: Wed Oct 10th, 2018 02:57 pm

Quote

Full Topic

JAMMAN
Owns A Torsen

Joined: Mon Sep 18th, 2017

Location: Grove City, Ohio USA

Posts: 6436

Status:

Offline

Reputation:

Reputation Points: $user_rep

Member's Gallery

Only this time I want to do it to last a while since I intend on keeping this truck for a few years.

I know a few of you had suggestions on better than average aftermarket balls and upper arms, so I'm going to research based on the suggestions rather than start fresh.

This one will have a V8 planted in it.

I plan on replacing wheel bearings, upper and lower bj, and shocks all at the same time. I'm cranking the T bars too about an inch.

I have had unusual good luck with the Detroit Axle stuff as some of you know but I don't want my luck to run out on my favorite project.

I really want to stay away from Moog unless there is a specific serial number I need to look for. I can't find the thread where 410 posted his choice for lowers.

____________________
00 XLT 4WD RCSB 3.GO! JalapeÃ±o
01 XLT 2WD RC Steppie 3.0 auto Silver
The future belongs to those who show up.