| PM | Quote | Reply | Full Topic |
Seasoned...
Joined: Sat Oct 21st, 2017
Location: Near The Pointy End , USA
Posts: 1295
Status:
Offline
Reputation: 
Reputation Points: $user_rep
No little tag on the rear end itself?
You can turn the driveshaft and tell easily. Lock one drum up with vise grips if it isn't posi, paint marker the other. turn the driveshaft till the paint mark on the drum passes twice, the times the driveshaft turned is the ratio.
If it is posi one turn of the drums because both drums will turn at the same time.
Man that is one clean looking frame.
Negative, it was broken off and like I stated, the drivers side door was MIA when I got to the JY unfortunately along with the Drivers fender too. I have an extra Passenger door and fender for sale tho.. lol I will have to try the drum/axle turn method and see what I come up with. Although I've heard of it in a post or two I've never tried that myself nor seen it done so that will be something new for me.
And yes, thats what 95% of all Western frames look like but I've seen my share of S. Eastern Michigan frames ;)
410customs wrote:
Yes there was a center console usually between the 50 50 seats it would be this style
Hmmmmm.. Do you have any shots of the top and the inside compartmental areas? if not no worries. I just wonder if it has some functionality (in creative senses) over the intended functionality from Ford.
Scrambler82 wrote:
EDITED: Don't know what happened, took a lot of typing to get it posted.
I sent Chris a PM to it checked out !
I will clean up the "gibberish" if Chris can't clean it up !
_________________________________________________________________
Here is a shot of the my Overhead Console (OHC) after the switch plate was finished, I my change thing a little, will a new Map/Interior Light LED Module.
The Switches I used are micro switches and now there are indicator lights too, four small micro LEDs, but not shown in the picture. I will either get some new better quality switches or maybe reduce the number of switches.
I ran the wiring inside of the roof structure just above the headliner, everything comes down the side post behind the driver and across the door; it's only low amperage, shouldn't be any problem. Now all I need to do is decide on the upgrades to the OHC and get power to it.
I didn't want the readout that would normally go there so I made the plate, four switch for accessories, two switches for interior Map Lights; made my own LED module for each Map Light.
But everyone to their own.
I didnt catch or see the pic (?)..
What are the switch functions for again? I at one time was going to use the digital readout for temperature with the temperature sensor with the audio systems amplifier but.. moving to the desert areas I already know its hot as hell, don't need a digital anxiety. lol
____________________
"Be never first, never last and never noticed." - Unknown
"The slave is held most securely when he is held by the chains of his own will and of his own fears, and when he is locked down by his own slavish desires for a comfortable life." - Michael Bunker
"Mundus vult decipi, ergo decipiatur" - ~ attributed to Petronius (Gaius Petronius Arbiter (ca. 27–66 AD))
Roman courtier during the reign of Nero.
"Those who expect to reap the blessings of freedom, must, like men, undergo the fatigue of supporting it." - Thomas Paine
~ Undrstm8ed Truckumentry Write Up Pg.
~ Undrstm8ed Trailermentry Write Up Pg.
.