| PM | Quote | Reply | Full Topic |
Old Bastard !
Joined: Fri Dec 22nd, 2017
Location: California USA
Posts: 2108
Status:
Offline
Reputation: 
Reputation Points: $user_rep
I sent Chris a PM to it checked out !
I will clean up the "gibberish" if Chris can't clean it up !
_________________________________________________________________
Here is a shot of the my Overhead Console (OHC) after the switch plate was finished, I my change thing a little, will a new Map/Interior Light LED Module.
The Switches I used are micro switches and now there are indicator lights too, four small micro LEDs, but not shown in the picture. I will either get some new better quality switches or maybe reduce the number of switches.
I ran the wiring inside of the roof structure just above the headliner, everything comes down the side post behind the driver and across the door; it's only low amperage, shouldn't be any problem. Now all I need to do is decide on the upgrades to the OHC and get power to it.
I didn't want the readout that would normally go there so I made the plate, four switch for accessories, two switches for interior Map Lights; made my own LED module for each Map Light.
But everyone to their own.
____________________
Ltr,
2003 EDGE, Std Cab, Steppie, E4 Red, 5sp, 4x
5" SuperLift, 33" x 12.50 x 15"
Hurst Shifter
Mod'd Backrack to fit Steppie
Front and Rear Bumpers by Custom 4x4 Fabrication, OK; now Mike's Welding and Fabrication.
Working on more Mods, just need more time, longer days would work !