| PM | Quote | Reply | Full Topic |
Owns A Torsen
Joined: Mon Sep 18th, 2017
Posts: 6429
Status:
Offline
Reputation: 
Reputation Points: $user_rep
Today I replaced the antenna lead/cable from the antenna base to the radio (wow what a pain in the butt). Radio stations come in a lot better now. To replace the antenna lead I cut the end that off that plugged into the radio since it was messed up anyway, stripped back some of the outer covering so all that was left was the plastic inner liner & the metal wire & slipped the plastic part into the end of the replacement antenna lead that would plug into the antenna base & duct tapped them together. Then with a long thin screw driver going through the antenna hole in the cowl I popped out the rubber grommet in the firewall & cut it off the old antenna lead. Then taking my time I just fed the replacement antenna lead through the firewall while slowly pulling the old antenna lead out of the hole in the cowl until the replacement antenna lead was into the cowl. I also installed a radio interface that has a audio input, usb port, & the on/off switch that controls the interface. I removed the ash tray assembly & made a face plate to cover the cubbie opening where I installed the usb port, audio input port, & the on/off switch. Here is what it looks like.
Nice, I dig adding accessories and making them look like they were born there!
____________________
00 XLT 4WD RCSB 3.GO! Jalapeño
01 XLT 2WD RC Steppie 3.0 auto Silver
The future belongs to those who show up.