| View single post by Whisky | |||||||||
| Posted: Sun Jun 3rd, 2018 01:35 pm |
|
||||||||
Whisky Joined: Mon Apr 23rd, 2018
Location:
Posts: 8
Status:
Offline
Reputation:  Reputation Points: $user_rep
|
WOW you are really going all out {which is good}, I didn't do none of that. I just started cutting small and progressed bigger until the projector fit, mounted housing to outside table, hooked up a 12volt power converted to power projector, adjusted cut-off horizontally against my fence, JB weld projector into housing-done, start other one. You can use a heat gun to separate lens but oven is much better. FYI some of the aftermarket housing are a real BIG PITA to get apart, much harder than the factory ones for whatever reason?
____________________ 2001 4x4 stepside, 3"BL, 33" bfg k02, 15x10 clasicII, Custom Catback. UWS LP Toolbox, MOOG suspension comp.,EBC sport rotors, EBC green 7000 pads, Retro`d TRS FX-R 3.0 3" Projectors, CBB 7000K |
||||||||
|
| |||||||||