View single post by 1qaz

Posted: Sun May 27th, 2018 08:37 pm

Quote

Full Topic

1qaz

Joined: Sun Feb 25th, 2018

Location: USA

Posts: 198

Status:

Offline

Reputation:

Reputation Points: $user_rep

Member's Gallery

So I pulled everything back out...input shaft is fine, alignment tool is damn near the exact same size...put a single strip of electrical tape on it ensure it was snug. Here's the alignment after I torqued all the pressure plate bolts to spec.

I'm using a transmission jack but once I get the transmission in place to start wiggling and pushing it's in the way. I think my issue is the alignment of the engine to the bell housing. I'm struggling with getting a straight shot at pushing it in there. I'll give it another try tomorrow...I stopped for the day just as the temp reached 100F...it snowed less than a month ago...that's a whole nother issue.

Thanks for the all the tips. I'll eventually get this...and do a happy dance when I do.