| PM | Quote | Reply | Full Topic |
Old Bastard !
Joined: Fri Dec 22nd, 2017
Location: California USA
Posts: 2108
Status:
Offline
Reputation: 
Reputation Points: $user_rep
In my write up I went with the D2S due to more common D2S bulb. The 98-00 also had deeper housings so a D2S was no issue.
IIRC someone (or someones) used Mini H1 projectors in their 01+ housings and it fit without cutting the housings up.
I would grab a stick and remove the halogen bulb and push it in straight until it contacts the lens to see how much depth you got.
Thanks for posting.
I have 3 3/8", measured with a tape measure from the outside of the Bulb Mounting Flange.
The D2S's I was looking at have a measurement of 2 7/8" from the mounting flange to the end od the lens.
Somehow I wanted to cut off the rear of the housing so the Lens of the Projector was approximately 3/8" to 1/2" away from the Housing face.
That's as far as I have gone.
Was going to order the D2S's Kit with Halos from The Ranger Station and do some more measuring and see where it all comes out; I did contact a couple of local companies that were suggested by The Ranger Station but they have not responded.
____________________
Ltr,
2003 EDGE, Std Cab, Steppie, E4 Red, 5sp, 4x
5" SuperLift, 33" x 12.50 x 15"
Hurst Shifter
Mod'd Backrack to fit Steppie
Front and Rear Bumpers by Custom 4x4 Fabrication, OK; now Mike's Welding and Fabrication.
Working on more Mods, just need more time, longer days would work !