View single post by Tsquare

Posted: Mon Apr 9th, 2018 06:43 pm

Quote

Full Topic

Tsquare

Joined: Fri Nov 10th, 2017

Location: Suwanee, Georgia USA

Posts: 1540

Status:

Offline

Reputation:

Reputation Points: $user_rep

Member's Gallery

I finally go around to working on the AR-9. I decided it needed a full cleaning in addition to replacing the charging handle. This is the first deep clean and it has just over 1100 rounds through it. Since it is a blow-back design it runs very dirty.

I pulled the drop in trigger out and ran cleaning solution through it until it ran clean. There was a lot of gunk that came out. When I was putting it back together I somehow misplaced one of the pin screws for the trigger. After 2 hours of cleaning and looking for it I finished putting the gun back together.

I have a new trigger that I can rob parts from but I will need to replace them eventually. I shot off an email to the manufacturer to see if they would provide the size so I could source it locally.

____________________
Tony
NE ATL
'04 XLT regular cab 3.slo stepside
Semi retirement