1
View single post by JAMMAN
 Posted: Sat Mar 17th, 2018 02:50 pm
PM Quote Reply Full Topic
JAMMAN
Owns A Torsen


Joined: Mon Sep 18th, 2017
Location: Grove City, Ohio USA
Posts: 6429
Status: 
Offline
Reputation: 
Reputation Points: $user_rep
Member's Gallery
 OK Guys (and the one gal so far) I'm heading in to something I have never done on a torsion bar ranger. I'm replacing all 4 ball joints, 2 tie rod ends and the wheel bearings/hub.

No stranger to front ends but I USUALLY buy an entire upper control arm with the ball joint in it. This time due to that unusual adjustment thingy on the right side I want to just press the ball joints in. We have ample equipment at where I work to do this.

Problems/concerns/ thoughts from people who have actually done it on a torsion bar ranger?

I'm looking forward to it but if there is any strange thing I should know before hopping in to it please do tell.



____________________
00 XLT 4WD RCSB 3.GO! Jalapeño
01 XLT 2WD RC Steppie 3.0 auto Silver
The future belongs to those who show up.